03.030.0101: Flexible flashing, drip edge, termination bar, drainage mat
03.030.0101 - Flexible flashing, drip edge, termination bar, drainage mat DOWNLOAD DetailDynamic 3D Detail01.030.0804: Roof-Wall, Brick veneer, CMU Backup, Tigid Insul. W/ Taped Joints, Veneer Ties
This wall system shows brick veneer, concrete masonry backup, rigid insulation with integral facer and taped joints, and veneer ties tying the brick back to the block. The taped joints in the insulation serve as the wall’s air barrier per insulation manufacturer’s recommendations. View a 2D cross-section of the detail.
02.410.0114: Block Cleanout
DOWNLOAD DETAIL06.070.0102: Wall Tile – One Coat Method, Non-Wet Area
06.070.0102: Wall Tile - One Coat Method, Non-Wet Area This detail shows tile over concrete masonry (CMU) laid in the one-coat method in a non-wet area. There is metal lath embedded in a bed of mortar, with the tile adhered to a dry-set or latex-modified portland cement mortar bond coat. This detail is based on [...]07.130.0327: Polyacrylate Terrazzo – Full Crack Isolation Membrane
DOWNLOAD DETAIL02.120.0711: Floor Connection Detail – Option 1
02.120.0711: Floor Connection Detail - Option 1 DOWNLOAD DETAIL02.410.0142: U-Block CMU Bond Beams
DOWNLOAD DETAIL02.010.0311: Base of Wall Detail – Single Wythe Block, Split Base Course
This detail shows an 8” (nominal) split face concrete masonry (CMU) wall, base of wall condition. The base course is divided into two wythes of 4” (nominal) CMU to allow for a vertical upturn to the flashing. The flashing is shown as a flexible material for the through-wall portion, transitioning to a sheet metal drip […]